AEG Electrolux FAVORIT 88010 VIL User Manual page 33

Display message and malfunction
• intermitted audible signal
• message OPEN THE TAP in the display
• point-shaped optical signal flashing
The dishwasher does not fill with water
• intermitted audible signal
• message DRAIN BLOCKED in the display
• point-shaped optical signal flashing
The dishwasher will not drain
• intermitted audible signal
•
appears in the display
• point-shaped optical signal flashing
Anti-flood device is activated
• intermitted audible signal
• message SPRAY ARM BLOCKED in the dis-
play
• point-shaped optical signal flashing
The programme does not start.
Once these checks have been carried out, switch on the appliance: the programme
will continue from the point at which it was interrupted.
If the malfunction or fault code reappears contact the Service Force Centre.
What to do if...
Possible cause and solution
• The water tap is blocked or furred with lime-
scale.
Clean the water tap.
• The water tap is turned off.
Turn the water tap on.
• The filter (where present) in the threaded hose
fitting at the water inlet valve is blocked.
Clean the filter in the threaded hose.
• The water inlet hose has not been correctly
laid or it is bent or squashed.
Check the water inlet hose connection.
• The sink spigot is blocked.
Clean out the sink spigot.
• The water drain hose has not been correctly
laid or it is bent or squashed.
Check the water drain hose connection.
• Close the water tap and contact your local
Service Force Centre.
• Open the door carefully.
• Arrange dishes and cutlery in the baskets so
that the upper spray arm can rotate freely.
• Close the door.
• The dishwasher's door has not been properly
closed. Close the door.
• The main plug is not plugged in. Insert the
main plug.
• The fuse has blown out in the household fuse
box.
Replace the fuse.
• Delay start has been set.
If dishes are to be washed immediately, cancel
the delay start.
33