Physical Details - Planet ICA-310 User Manual

2.2 Physical Details

Identification of ICA-310 cables
RS-485 (Blue: D+ / Red: D- ):
Connect to a Pan/Tilt external scanner unit.
This connector is built inside the ICA-310 housing. If
you need to install the RS-485, please contact your
dealer for more information.
NOTE: The RS-485 of ICA-310 is master that can
control external scanner.
Power Connector:
The input power is 12VDC.
NOTE: Supplies the power to the ICA-310 with the
power adapter included in package.
Video Output Connector (BNC port):
The ICA-310 also provides composite video output.
User can use BNC video cable to connect the ICA-310
with a TV monitor or DVR.
RJ-45 LAN Connector:
For connect a LAN cable to your Hub/Switch or PoE
device.
The LAN port is a RJ-45 connector for connections to
10Base-T Ethernet or 100Base-TX Fast Ethernet
cabling. This Ethernet port built N-Way protocol can
detect or negotiate the transmission speed of the
network automatically. Please use Category 5
"straight" cable to connect the ICA-310 to a 100Mbps
Fast Ethernet network switch or hub. If you are plan to
connect the ICA-310 to a PoE device (such as PoE
switch) to get the power source, you will also connect
the RJ-45 cable from this connector to the PoE device.
NOTE: In case you need to connect the device to PC
or notebook directly, you should use a cross-over
cable instead.
Use only one power source, either 12VDC or Power
over Ethernet through UTP cable at one time. Use of
both powers will damage the camera permanently.
7