Installing A Diskette Drive In Bay 3 - Lenovo ThinkCentre 8328Types 8341, 8344, 8382 User Manual

3. Connect one end of the signal cable to the drive and the other to the PATA
4. Locate the extra four-wire power connector labelled P4 and connect it to the
Connecting an additional serial ATA hard disk drive
A serial hard disk drive can be connected to any available SATA connector.
1. Locate the signal cable that comes with the new drive.
2. Locate the available SATA connector on the system board. See "Identifying
3. Connect one end of the signal cable to the drive and the other to the available
4. Locate one of the extra five-wire power connectors and connect it to the drive.

Installing a diskette drive in bay 3

To install a diskette drive in bay 3, do the following:
20
User Guide
primary IDE connector on the system board.
drive.
parts on the system board" on page 13.
SATA connector on the system board.
What to do next:
v To work with another option, go to the appropriate section.
v To complete the installation, go to "Closing the cover and connecting the
cables" on page 25.
1. Open the computer cover. See "Opening the cover" on page 10.