Setting The Water Softener - AEG FAVORIT 85060 VI User Instructions

Operating Instructions
1) The water hardness will only be indicated acoustically if the acoustic signal has
been activated.
2) (°d) German degree, measure of the hardness of water
3) [mmol/l] millimol per litre, international unit for the hardness of water
4) On this setting the length of the dishwashing cycle may be slightly longer.
*) Factory setting

Setting the water softener

Using the table as a guide, adjust the water softener to that which cor-
responds to the hardness of the water in your area:
0 The dishwasher must be switched off.
Setting manually:
1. Open the dishwasher door.
2. Remove the lower rack from the
dishwasher.
3. Turn the hardness range switch to 0
or 1 (see table).
4. Replace the lower rack.
Setting electronically:
5. Press the ON/OFF button.
The LED indicators for all the buttons in the control panel that are now
able to be selected will become illuminated.
If the only LED indicator illuminated is one that belongs to a pro-
3
gramme button, this means that this dishwashing cycle has been acti-
vated. The dishwashing cycle must be cancelled:
Press function buttons 2 and 3 simultaneously for approx. 1 second.
The LED indicators for all the buttons in the control panel that are now
able to be selected will become illuminated.
6. Press function buttons 2 and 3 simultaneously and keep them pressed.
The LED indicators in function buttons 1 to 3 will flash.
7. Press function button 1.
The LED indicator for function button 1 will flash.
The multi-display will indicate the hardness setting.
The number of the acoustic signals heard (only when the acoustic sig-
nal has been activated) also corresponds to the hardness setting.
8. Pressing function button 1 increases the hardness setting by 1.
(Exception: hardness setting 1 follows hardness setting 10).
12