Table of Contents
Advertisement
Putting in extra items or taking items out before end of
programme
1. Open loading door
1
Warning! Laundry and drum can become hot. Risk of burns!
2. Load or remove laundry items.
3. Close loading securely. Lock must audibly lock.
4. Press the START/PAUSE (START/PAUZE) button to continue the drying
cycle.
Drying cycle complete / removing laundry
Once the drying cycle is complete, the END (EINDE) and CREASE GUARD
(ANTI-KREUK) displays light up. If the AUDIBLE SIGNAL (ZOEMER) but-
ton has been pressed, an audible signal sounds intermittently.
3
The drying cycle is automatically followed by a crease guard phase
which lasts around 30 minutes. The drum rotates in intervals during
this phase. The laundry thereby remains relaxed and free of creases. The
laundry can be removed at any time during the crease guard phase.
(The laundry should be taken out towards the end of the crease guard
phase at the latest to prevent creases from forming.)
1. Open loading door
2. Before removing the laundry, remove lint from the micro-fine filer. It is
best to use a damp hand for this purpose (refer to "Cleaning and main-
tenance" section).
3. Remove laundry.
4. Turn the programme selector to OFF (UIT).
Important! After each drying cycle
– clean the micro-fine filter and fine strainer,
– drain the condensate tank
(refer to the "Cleaning and maintenance" section).
5. Close loading door.
15
Advertisement
Table of Contents
