Cpu Removal And Installation ("Pick N Place") Tool Set; Thermal Grease (With Syringe Applicator) For Cpu To Heatsink Seal - Cisco UCS C240 M3 Specifications

SUPPLEMENTAL MATERIAL
http://www.cisco.com/en/US/docs/unified_computing/ucs/c/hw/C240/install/replace.html#wp1307315

CPU Removal and Installation ("pick n place") Tool Set

The Pick n Place tool set includes two tools:
Pick and pull cap tool - used to pull off the plastic protective cap covering an empty CPU socket and
■
to remove or lift a CPU processor without touching it
Pick and place tool - used to install a CPU in its socket without damage. Must be used each time a
■
CPU is installed in a UCS "M3" server.
Instructions for using this tool set are found at the following link:
http://www.cisco.com/en/US/docs/unified_computing/ucs/c/hw/C240/install/replace.html#wp1233864

Thermal Grease (with syringe applicator) for CPU to Heatsink Seal

Thermal grease must be applied to the top of the CPU where it comes in contact with the heat sink.
Instructions for applying thermal grease are found at:
http://www.cisco.com/en/US/docs/unified_computing/ucs/c/hw/C240/install/replace.html#wp1233864
78
NOTE: When you purchase a spare CPU, the Pick n Place Toolkit is included.
CAUTION: Use only the thermal grease specified for this server
(UCS-CPU-GREASE2=). This thermal grease comes in a red-tipped syringe
and is to be used only in the C220 M3 and C240 M3 servers. Other servers
use thermal grease in a blue-tipped syringe (UCS-CPU-GREASE=).
Thermal grease for other systems may have different thermal
conductivity properties and may cause overheating if used in the C220 M3
or C240 M3 servers.
DO NOT use thermal grease available for purchase at any commercial
electronics store. If these instructions are not followed, the CPU may
overheat and be destroyed.
CAUTION:
NOTE: When you purchase a spare CPU, the thermal grease with syringe applicator
is included.
Cisco UCS C240 M3 High-Density Rack Server (Small Form Factor Disk Drive Model)