Table of Contents
Advertisement
TECHNICAL INFORMATION FOR THE
INSTALLER
Installation, adjustments of controls and
maintenance must only be carried out by a
qualified engineer.
Incorrect installation may cause damage to
persons, animals or property for which the
Manufacturer shall not be considered
responsible.
During the life of the system, the automatic
safety or regulating devices on the appliance
may only be modified by the manufacturer or by
his duly authorized dealer.
4) INSTALLING THE HOT PLATE
Check that the appliance is in a good condition after
having removed the outer packaging and internal
wrappings from around the various loose parts. In
case of doubt, do not use the appliance and contact
qualified personnel.
Never leave the packaging materials (cardboard,
bags, polystyrene foam, nails, etc.) within
children's reach since they could become
potential sources of danger.
The measurements of the opening made in the top
of the modular cabinet and into which the hot plate
will be installed are indicated in either fig. 9. Always
comply with the measurements given for the hole
into which the appliance will be recessed (see
fig.10).
FIG. 9
INSTALLATION
4A) CYLINDER HOLDER COMPARTMENT
The dimensions of the cylinder compartment have to
permit the easy loading and unloading of the
cylinder.
For an efficient aeration is necessary to make some
small openings in the furniture, as per fig. 9/A and 9/B.
The cylinder holder compartment must have the
following characteristics:
- Resistance to a load.
- No fitment of the cylinder directly on the floor are
allowed.
- The cylinder equipped with governor must be set
or take off from the compartment in a easy way.
- The cylinder cock must be easily accessible.
- The flexible tube musn't be in contact with sharp
edges.
- The cylinder holder compartment and the different
parts of the unit, where the burners are fit, musn't
be in touch inside.
- The aeration openings musn't be occluded when
the unit is installed.
The appliance belongs to class 3 and is
therefore subject to all the provisions
established by the provisions governing such
appliances.
FIG. 9/A
8
COMPLY WITH THE DIMENSIONS
A
B
4F
553
473
FIG. 9/AB
C
D
E
65
62
65 min.
FIG. 10
Hide quick links:
Advertisement
Table of Contents
