AEG 25658G-M Instructions For Use, Installation And Maintenance page 9

5) FIXING THE HOT PLATE
The hot plate has a special seal which prevents
liquid from getting into the cabinet. Strictly comply
with the following instructions in order to correctly
apply this seal:
- Detach the seals from their backing, checking that
the transparent protection still adheres to the seal
itself.
- Overturn the hot plate and correctly position seal
"E" (fig. 11) under the edge of the hot plate itself,
so that the outer side of the seal perfectly matches
the outer edge of the hot plate. The ends of the
strips must fit together without overlapping.
- Evenly and securely fix the seal to the hot plate,
pressing into place with the fingers and remove the
strip of protective paper from the seal and set the
plate into the hole made in the cabinet.
FIG. 11
INSTALLATION
- The prospective walls (left or right) that exceed the
working table in height must be at a minimum
distance from the cutting as mentionned both in
the columns and the scheme.
- Fix the hob with the proper brackets "S" and fit the
prominent part into the porthole "H" on the bottom;
turn the screw "F" until the bracket "S" stick on the
top (fig. 12).
- In order to avoid accidental touch with the
overheating bottom of the hob, during the working,
is necessary to put a wooden insert, fixed by
screws, at a minimum distance of 50mm from the
top (see fig. 9)
Remark: Below is the suggested clearances. Actual
installation will be veried subject to different kitchen
situations.
9
FIG. 12