GMC 300W Instruction Manual page 4

Damage to the lungs if an effective breathing
mask is not worn.
Damage to hearing if effective earmuffs are not
worn.
Damage to the eyes if effective safety goggles or
shield are not worn.
Warning.
When using power tools, basic safety
precautions should always be taken to reduce the risk of
fire, electric shock and personal injury. Also, please read
and heed the advice given in the additional important
safety instructions.
1.Keep the work area clean and tidy.
areas and benches invite accidents and injury.
2.Consider the environment in which you are working.
Do not use power tools in damp or wet locations.
Keep the work area well lit. Do not expose power tools
to rain. Do not use power tools in the presence of
flammable liquids or gases.
3.Keep visitors away from the work area.
and onlookers, especially children and infirm persons,
should be kept well away from where you are working.
Do not let others in the vicinity make contact with the
tool or extension cord.
4.Store tools safely. When not in use, tools should be
locked up out of reach.
5.Do not force the tool.
and safer working at the rate for which it was designed.
6.Use the correct tool for the job.
tools or attachments to do the job best handled by a
heavier duty tool. Never use a tool for a purpose for
which it was not intended.
7.Dress correctly. Do not wear loose clothing or jewellery.
They can be caught in moving parts. Rubber gloves
and non-slip footwear are recommended when working
outdoors. If you have long hair, wear a protective hair
covering.
Cluttered work
All visitors
The tool will do the job better
Do not force small
8.Use safety accessories.
should always be worn. A face or dust mask is also
required if the sanding operation creates dust.
9.Do not abuse the power cord.
disconnect the tool from the power point. Keep the cord
away from heat, oil and sharp edges.
10. Secure the work piece.
the work piece. It is safer than using your hand and
frees both hands to operate the tool.
11. Do not overreach.
balanced at all times.
12. Look after your tools.
clean for better and safer performance. Follow the
instructions regarding lubrication and accessory
changes. Inspect tool cords periodically and, if
damaged, have them repaired by an authorised
service facility. Inspect extension cords periodically
and replace them if damaged. Keep tool handles dry,
clean and free from oil and grease.
13. Disconnect idle tools.
disconnect the plug from the power point before
servicing, when changing accessories and when the
tool is not in use.
14. Avoid unintentional starting.
switch is in the OFF position before plugging in the
tool to the power supply. Do not carry a plugged in
tool with your finger on the switch.
15. Use outdoor rated extension cords.
is used outdoors, use only extension cords that are
intended for outdoor use and are so marked.
16. Stay alert. Watch what you are doing.
common sense. Do not operate a power tool when
you are tired.
17. Check for damaged parts.
check that there are no damaged parts. If a part
is slightly damaged, carefully determine if it will
operate properly and perform its intended function.
Check for alignment of moving parts, binding of
4
Safety glasses and earmuffs
Never pull the cord to
Use clamps or a vice to hold
Keep your footing secure and
Keep tools sharp and
Switch off the power and
Always check that the
When a tool
Use
Before using a tool,