Care And Cleaning - Electrolux EW F147410 A User Manual

CHANGE A FUNCTION
You can change only the delay and spin
function before they operate.
Press the related button to set the new val-
ue.
SET THE DELAY START
1. Press the delay start button again and
again until the display shows the num-
ber hours.
2. Press the start button, the appliance
starts the countdown of the delay start.
The symbol h flashes in the display and
the start button indicator is off.
When the countdown is completed, the
programme starts automatically and
the start button indicator comes on.
You can cancel or change the set of
the delay start also when the appliance
starts the countdown.
CANCEL THE DELAY START
Press the delay start button again and
again until the display shows 0.
The programme starts and the start button
indicator comes on.
OPEN THE DOOR
While a programme operates, the appliance
door is locked.
To open the appliance door:
1. Turn the programme knob to
activate the appliance.
2. Wait for some minutes before to open
the appliance door.
3. Close the appliance door.
4. Set the programme again.
If the temperature and level of the wa-
ter in the drum are too high, you can-
not open the door.
To open the appliance door:
• Do the steps 1 and 2 again.
• Wait for some minutes.

CARE AND CLEANING

Warning!
Disconnect the appliance from the mains
supply before you clean it.
• Make sure that no water is in the
drum.
AT THE END OF THE PROGRAMME
• The appliance stops automatically.
• The display shows the End symbols.
• Turn the programme knob to
tivate the appliance.
• Remove the laundry from the appliance.
Make sure that the drum is empty.
• Keep the door ajar, to prevent mildew
and odours.
• Close the water tap.
The washing programme is completed,
but there is water in the drum:
– The Rinse Hold function or a programme
that stops with water in the drum is set.
– The door stays locked and the start but-
ton indicator flashes.
– You must drain the water before to open
the door.
To drain the water:
1. If necessary, decrease the spin speed.
2. Press the start button. The appliance
drain the water and spin.
3. When the programme is completed:
– The display shows the End symbols.
– You can open the door.
4. Turn the programme knob to
activate the appliance.
STAND BY
to de-
After some minutes the end of the washing
programme, if you do not deactivate the
appliance, the energy saving status acti-
vates.
The energy saving status decreases the en-
ergy consumption when the appliance is on
standby.
• The brightness of the display goes off.
• The display shows the symbol End.
• All indicators go off.
Press one of the buttons to deactivate the
energy saving status.
EXTERNAL CLEANING
Clean the appliance only with soap and
warm water. Fully dry all the surfaces.
electrolux 11
to deac-
to de-