Bowens DUO-LITE HEAD Operating Installations

Bw-3015

Advertisement

Quick Links

DUO-LITE HEAD
OPERATING INSTRUCTIONS
Covers Models
BW-3015

Advertisement

Table of Contents
loading

Summary of Contents for Bowens DUO-LITE HEAD

  • Page 1 DUO-LITE HEAD OPERATING INSTRUCTIONS Covers Models BW-3015...
  • Page 2 Figure 1 Rear Control Panel Key To Figure 1 A. Modelling Lamp Fuse B. Spare Fuse under Handle Insert C. Modelling Lamp On/Off Switch Figure 2 Mounting Bracket Key To Figure 2 A. Mounting Bracket B. Umbrella Hole C. Umbrella Knurled Knob D.
  • Page 3 Important Safety Notes - Please Read Before Operating Head Please read and follow these basic safety instructions: READ and UNDERSTAND the instructions and specifications. NEVER replace the fuse with that of a different type or rating. See Specification for correct value/type of fuse. ALWAYS avoid placing Flash Head cables where they can be tripped over.
  • Page 4: General Features

    General Features The Duo-Lite Head is designed for use with the Duo1200, Duo 2400 and Duo 4800 Packs. Operating from a nominal 230 volt mains supply only, features include: 650 Watt maximum modelling power. Two pin plug-in lamp holder. (Recommended Halogen bulb - P2/16 hair pin, long life type.) Easy fitting of the standard ‘S’...
  • Page 5 Figure 3 Fitting / Removing Reflector Key To Figure 3 A. Latch Knob B. Dome Retaining Buttons Fitting / Replacing Modelling Lamps ALWAYS switch ‘OFF’ the Pack and remove the connector to isolate the Head before replacing the modelling lamp. If the modelling lamp is not lit but the Head switch is on and the pack controls have no effect then:- •...
  • Page 6: Circuit Protection

    Circuit Protection Circuit protection for the modelling lamp is provided by means of a 20 mm fuse mounted on the rear of the Head. The fuse is rated at 6.3 Amp and should never be replaced with a fuse of a different type or rating. The spare fuse is retained under the printed handle insert (Fig.1).
  • Page 7: Flash Duration

    160 x 145 mm WEIGHT 4 kg Due to our policy of constant product improvement Bowens International Limited reserve the right to change equipment specifications without notice. Accessories A number of accessories to fit this Pack and Flash Head system are available and include a full range of Stands, Umbrellas, Reflectors and Register Wafers etc.
  • Page 8 DUO-LITE HEAD INSTRUCTIONS BWL-0270/1 17-02-99 BOWENS INTERNATIONAL LIMITED 355 OLD ROAD CLACTON-ON-SEA ESSEX CO15 3RH ENGLAND Tel: +44(0)1255 422807 Fax: +44(0)1255 436342 - 8 -...

This manual is also suitable for:

Bw-3015

Table of Contents