Table of Contents
Advertisement
12.7 Emergency drain
Because of a malfunction, the appliance
cannot drain the water.
If this occurs, do steps (1) through (3) of
'To clean the drain filter'.
If necessary, clean the filter.
Put the drainage duct back and close the
drain filter flap.
12.8 Frost precautions
If the appliance is installed in an area
where the temperature can be less than
0 °C, remove the remaining water from
the inlet hose and the drain pump.
1.
Close the water tap and disconnect
the inlet hose.
13. TROUBLESHOOTING
The start of the appliance does not oc-
cur or it stops during operation.
First try to find a solution to the problem
(refer to the table). If not, contact the
service centre.
With some problems, the acoustic
signals operate and the display shows
an alarm code:
•
- The appliance does not fill with
water.
Problem
The appliance
does not fill with
water.
90˚
Possible cause
The water tap is closed.
6.
Install again the inlet hose. Make
sure that the couplings are tight to
prevent leakages.
7.
Open the water tap.
2.
Put the end of the inlet hose in a
container and let the water flow out
of the hose.
3.
Do the Drain programme and let it
operate until the end of the cycle.
4.
Turn the programme knob to Stop
to disconnect the appliance from the
power supply.
5.
Disconnect the appliance.
WARNING!
Make sure that the temperature
is more than 0 °C before you use
the appliance again.
The manufacturer is not responsi-
ble for damages caused by low
temperatures.
•
- The appliance does not drain
the water.
•
- The appliance door is open or
not closed correctly.
•
- The anti-flood device is on.
WARNING!
Deactivate the appliance before
you do the checks.
Possible solution
Open the water tap.
ENGLISH
19
Advertisement
Table of Contents
