Table of Contents Page Safety Section TruStitch™ Regulator Components Pre-installation Instructions Installation Instructions Indicator LED Identification Activating Stitch Regulation Machine Operation Using the Stitch Regulator TruStitch™ Accessories Tips and Techniques Register your TruStitch™ ™ quilting machine powerquilter 16.0 Recommended for Use with the...
CLASS 1 Laser Product by turning the equipment off and on, The TruStitch™ controller contains an the user is encouraged to try to correct invisible laser device that complies with the interference by one or more of the stringent safety requirements.
The TruStitch™ controller uses a rechargeable Lithium-ion battery for Waste Electrical and Electronic power. Do not attempt to replace Equipment (WEEE) Directive this battery.
A machine interface cable connects the TruStitch™ receiver to the foot pedal connector on the machine. The foot pedal plugs into the TruStitch™ receiver and acts to enable the stitch regulation when in regulation mode. CE - Authorised Representative...
TruStitch™ Regulator Components TruStitch™ Controller Magnet TruStitch™ Receiver Coaster Figure 1. TruStitch™ Components Pre-installation Instructions Battery Charging The battery on the TruStitch™ controller may not be fully charged when the product arrives. It is a good idea to plug the...
Installation Instructions Caution: Use only the power Install each cable into the module that came with TruStitch™ to appropriate connector or port power the TruStitch™ receiver. If you (Figures 2 & 3). Please note that use a different power supply, such...
Page 8
Figures 4 & 5. Figure 4. USB Mini-B style charging Figure 5. Charging cable installed. port on the TruStitch™ Controller. Note flat on cable is up. With the machine and TruStitch™ controller turned off,...
Indicator LED Identification Both the TruStitch™ controller and receiver have indicator LEDs to guide Finder LED the user. Charge Indicator LED The controller has a flashing WHITE LED that flashes only in low Light Sensor light conditions, such as when it is under the quilt.
Manual Once the machine is powered up and the power module for the 25 % TruStitch™ receiver is plugged in, the machine will recognize that the Stitch Regulator is installed and will display a screen that looks like Figure 10.
Please note that operation and moves the needle to the the foot pedal must still be plugged chosen Needle Up/Down position. into the receiver for the TruStitch™ to Choosing a non-zero Idle value will work. re-engage the Idle setting.
Using the Stitch Regulator The TruStitch™ controller is designed to track the motion of the controller across the table, not the motion of the fabric during quilting. For proper stitch regulation, always keep the controller moving with the fabric as described below.
TruStitch™ Accessories Two accessories are provided with Free-motion quilt as usual while the TruStitch™ Stitch Regulator to keeping your hands close to the give the quilter more flexibility in controller. The controller will move quilting. with the quilt sandwich, regulating your stitch length.