General Safety Instructions - GMC BL5000A Instruction Manual

General safety instructions

To use this tool properly, you must observe the safety
regulations, the assembly instructions and the operating
instructions to be found in this Manual. All persons who use
and service the machine have to be acquainted with this
Manual and must be informed about its potential hazards.
Children and infirm people must not use this tool. Children
should be supervised at all times if they are in the area in
which the tool is being used. It is also imperative that you
observe the accident prevention regulations in force in your
area. The same applies for general rules of occupational
health and safety.
WARNING. When using power tools, basic safety precautions
should always be taken to reduce the risk of fire, electric
shock and personal injury. Also, please read and heed the
advice given in the additional important safety instructions.
1. Keep the work area clean and tidy.
areas and benches invite accidents and injury.
2. Consider the environment in which you are working.
Do not use power tools in damp or wet locations. Keep
the work area well lit. Do not expose power tools to rain.
Do not use power tools in the presence of flammable
liquids or gases.
3. Keep visitors away from the work area.
onlookers, especially children and infirm persons, should
be kept well away from where you are working. Do not
let others in the vicinity make contact with the tool or
extension cord.
4. Store tools safely. When not in use, tools should be
stored in a dry, high place or locked up out of the reach
of children.
5. Do not force the tool. The tool will do the job better and
safer working at the rate for which it was designed.
6. Use the correct tool for the job.
tools or attachments to do the job best handled by a
heavier duty tool. Never use a tool for a purpose for
which it was not intended. For instance, do not use
circular saws to cut tree limbs or logs.
7. Dress correctly.
8. Use safety accessories.
9. Do not abuse the power cord.
10. Do not overreach.
11. Look after your tools.
Cluttered work
12. Disconnect idle tools.
All visitors and
13. Avoid unintentional starting.
14. Use outdoor rated extension cords.
15. Stay alert.
Do not force small
16. Check for damaged parts.
4
Do not wear loose clothing or jewellery.
They can be caught in moving parts. Rubber gloves
and non-slip footwear are recommended when working
outdoors. If you have long hair, wear a protective hair
covering.
Safety glasses and earmuffs
should always be worn. A face or dust mask is also
required if the cutting operation creates dust.
disconnect the tool from the power point. Keep the cord
away from heat, oil and sharp edges.
Keep your footing secure and
balanced at all times.
Keep tools sharp and clean for
better and safer performance. Follow the instructions
regarding lubrication and accessory changes. Inspect
tool cords periodically and, if damaged, have them
repaired by an authorised service facility. Inspect
extension cords periodically and replace them if
damaged. Keep tool handles dry, clean and free from
oil and grease.
Switch off the power and
disconnect the plug from the power point before
servicing, when changing accessories such as blades,
bits and cutters, and when the tool is not in use.
switch is in the OFF position before plugging in the tool
to the power supply. Do not carry a plugged in tool with
your finger on the switch.
is used outdoors, use only extension cords that are
intended for outdoor use and are so marked.
Watch what you are doing. Use common
sense. Do not operate a power tool when you are tired
or under the influence of drugs or alcohol.
tool, a guard or other part that is damaged should be
carefully checked to determine if it will operate properly
Never pull the cord to
Always check that the
When a tool
Before further use of the