Yamaha Thunderace YZF1000R Owner's Manual page 56

PERIODIC MAINTENANCE AND MINOR REPAIR
1. Torque wrench
7. Install the new oil filter cartridge,
and then tighten it to the specified
torque with a torque wrench.
6
Tightening torque:
Oil filter cartridge:
17 Nm (1.7 m·kg)
8. Install the engine oil drain bolt, and
then tighten it to the specified
torque.
Tightening torque:
Engine oil drain bolt:
43 Nm (4.3 m·kg)
9. Add the specified amount of the
recommended engine oil, and
then install and tighten the oil filler
cap.
Recommended engine oil:
See page 8-1.
Oil quantity:
Without oil filter cartridge
replacement:
3.0 L
With oil filter cartridge
replacement:
3.2 L
Total amount (dry engine):
3.5 L
6-11
CAUTION:
_
In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives with
the oil or use oils of a higher
grade than "CD". In addition, do
not use oils labeled "ENERGY
CONSERVING II" or higher.
Make sure that no foreign mate-
rial enters the crankcase.
_
10. Start the engine, and then let it idle
for several minutes while checking
it for oil leakage. If oil is leaking,
immediately turn the engine off
and check for the cause.
NOTE:
_
After the engine is started, the engine
oil level warning light should go off if the
oil level is sufficient.
_
EC000072