Installation Location; Rehingeing The Door - AEG ARCTIS 1333-6 i Operating And Installation Instructions

Installation Location

The appliance should be set up in a well ventilated, dry room.
Energy use is affected by the ambient temperature. The appliance
should therefore
Ð not be exposed to direct sunlight;
Ð not be installed next to radiators, cookers or other continuossour-
ces of heat;
Ð only be installed at a location whose ambient temperature corre-
sponds to the climate classification, for which the appliance is desi-
gned.
The climate classification can be found on the serial plate, which is
located at the left on the inside of the appliance.
The following table shows which ambient temperature is correct for
each climate classification:
Climate classification
Your appliance needs air
For safety reasons, minimum venti-
lation must be as shown Fig.
Attention: keep ventilation ope-
nings clear of obstruction;

Rehingeing the door

The applianceÕs door have been locked in position for transport by
means of pins on both sides. According to the door opening direction,
remove relevant pins at the top and at the bottom.
Warning! When changing the side the door opens, the appliance may
not be connected to the mains. Remove plug from the mains befo-
rehand.
18
SN
N
for an ambient temperature of
+10 to +32 ¡C
+16 to +32 ¡C
50 mm
D567
min.
2
cm 200