AEG ARCTIS 1333-6 i Operating And Installation Instructions page 14

Malfunction
Appliance does not work.
Appliance cools too much.
The food is too warm.
Heavy build up of frost, pos-
sibly also on the door seal.
Unusual noises.
The compressor does not
start immediately after chan-
ging the temperature set-
ting.
14
Possible Cause
Appliance is not switched on Switch on the appliance.
Mains plug is not plugged in
or is loose.
Fuse has blown or is defec-
tive.
Socket is defective.
Temperature is set too cold. Turn the temperature regu-
Temperature is not properly
adjusted.
Door was open for an exten-
ded period.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
The appliance is near a heat
source.
Door seal is not air tight
(possibly after changing
over the hinges).
Appliance is not level.
The appliance is touching
the wall or other objects.
A component, e.g. a pipe,
on the rear of the appliance
is touching another part of
the appliance or the wall.
This is normal, no error has
occurred.
Remedy
Insert mains plug.
Check fuse, replace if
necessary.
Mains malfunctions are to be
corrected by an electrician.
lator to a warmer setting
temporarily..
Please look in the "Initial
Start Up" section.
Open the door only as long
as necessary.
Turn the temperature regu-
lator to a colder setting tem-
porarily.
Please look in the "Installa-
tion location" section.
Carefully warm the leaking
sections of the door seal
with a hair dryer (not hotter
than approx. 50 ¡C). At the
same time shape the war-
med door seal by hand such
that it sits correctly.
Readjust the feet.
Move the appliance slightly.
If necessary, carefully bend
the component out of the
way.
The compressor starts after
a period of time.