Orion Cobalt CO300.2 Owner's Manual page 13

Poor bass response
Crossover set incorrectly
Impedance load at amplifier is
too low.
Battery fuse blowing
Short in power wire or incor-
rect wiring.
Fuse used is smaller than rec-
ommended.
Actual current exceeds fuse
rating.
Amplifier fuse blowing
Fuse used is smaller than rec-
ommended.
Impedance load at amplifier is
too low.
Speaker is blown with shorted
outputs
Actual current exceeds fuse
rating
12
Reset crossovers. Refer to the
section of this manual for
detailed instructions.
Check speaker impedance load if below 2Ÿ,
rewire speakers to achieve higher impedance
.
Check power wires and ground connections
and repair or replace as needed.
Replace with proper fuse size.
Check speaker impedance load if below 2Ÿ,
rewire speakers to achieve higher impedance
.
Replace with proper fuse size.
Check speaker impedance load if below 2Ÿ,
rewire speakers to achieve higher impedance
.
Check system with known working speakers
and fix or replace as needed.
Check speaker impedance load if below 2Ÿ,
rewire speakers to achieve higher impedance
.
© 2007 directed electronics—all rights reserved