To Store Your Accessories; Cord Wrap; Wet/Dry Vac Assembly - RIDGID WD1665 Owner's Manual

SP6438 16 Gallon 7/26/06

To Store Your Accessories

Your RIDGID wet/dry vac is designed to
provide better stability, mobility and
accessory storage with the accessory
caddy. Located on the caddy are five
storage pockets. Conveniently store
accessory nozzles and extension wands
on these locations and use the front 2
caster feet storage pockets for the hose or
any of the accessories.

Wet/Dry Vac Assembly

1. Locate the lid assembly and the drum/
caster foot/caddy assembly (assembled
earlier).
2. Position the lid assembly with the inlet
of the unit located in line with the drain
cap on the dust drum.
3. To assemble the lid assembly to the
drum/caster foot/caddy
lower the lid assembly onto the dust
drum. Rotate both latches down until
you hear them snap over the lip of the
drum.
Drum Latch
9:38 AM Page 8

Cord Wrap

When vacuuming is complete, unplug the
cord and wrap it around the power
assembly as shown. The cord should wrap
under the pull handle (above the inlet) and
around and under the handle to the power
assembly.
Handle
Inlet
Lid
Assembly
assembly,
Dust
Drum
Drum Latch
Drum Lip
8
Pull Handle
Cord Wrap
Drain
Cap