AOpen AOR-411 User Manual page 36

Parameters
Enable Virtual Server
Private IP
Private Port
Type
Public Port
Comment
Add Virtual Server
Remove Virtual Server
Click <Apply> at the bottom of the screen to save the above configurations. You can now
configure other advanced sections or start using the router (with the advanced settings in place).
Example: Virtual Server
The diagram below demonstrates one of the ways you can use the Virtual Server function. Use
the Virtual Server when you want the web server located in your private LAN to be accessible to
Internet users. The configuration below means that any request coming from the Internet to
access your web server will be translated to your LAN's web server (192.168.2.2). Note: For the
virtual server to work properly, Internet/remote users must know your global IP address. (For
websites you will need to have a fixed/static global/public IP address.)
Description
Enable Virtual Server.
This is the LAN client/host IP address that the Public Port
number packet will be sent to.
Note: You need to give your LAN PC clients a fixed/static IP
address for Virtual Server to work properly.
This is the port number (of the above Private IP host) that the
below Public Port number will be changed to when the packet
enters your LAN (to the LAN Server/Client IP).
Select the port number protocol type (TCP, UDP or both). If you
are unsure, leave it to the default "both" protocol.
Enter the service (service/Internet application) port number from
the Internet that will be re-directed to the above Private IP
address host in your LAN.
Note: Virtual Server function will have priority over the DMZ
function if there is a conflict between the Virtual Server and the
DMZ settings.
The description of this setting.
Fill in the "Private IP", "Private Port", "Type", "Public Port" and
"Comment" of the setting to be added and then click "Add". Then
this Virtual Server setting will be added into the "Current Virtual
Server Table" below. If you find any typo before adding it and
want to retype again, just click "Clear" and the fields will be
cleared.
If you want to remove some Virtual Server settings from the
"Current Virtual Server Table", select the Virtual Server settings
you want to remove from the table and click "Delete Selected". If
you want remove all Virtual Server settings from the table, just
click "Delete All" button. Click "Reset" will clear your current
selections.
36