Electrolux WASL 3 T 200 User Manual page 6

6 electrolux
The display shows:
A
B
1) Only available for Spin/Drain programme.
C
The phase symbols
• When a programme is set, all the symbols of the phases related to the programme
come on.
• When the programme starts, only the symbol of the phase in operation flashes.
• When the programme is completed, the symbol of the last phase is on.
D
E
F
G
H
The temperature of the set programme
Cold water
The spin speed of the set programme
1)
No Spin symbol
Rinse Hold symbol
Prewash phase
Washing phase
Rinses phase
Spin phase
The steam symbol comes on when you set a Steam programme.
The detergent overdosing comes on at the end of the cycle when the ap-
pliance detects too much detergent.
You cannot open the appliance door when the symbol is on.
You can open the door only when the symbol goes off.
If the programme is completed but the symbol stays on:
• The 'Rinse Hold' function is on.
• There is water in the drum.
The delay start symbol comes on when you set the delay start function.
• The programme time
When the programme starts, the programme time decreases with steps
of 1 minute.
• The delay start
When you press the delay start button, the display shows the delay start
time.
• Alarm codes
If the appliance has a malfunction, the display shows alarm codes. Refer
to 'Troubleshooting'.
• The display shows this message for some seconds when:
– You set a function that is not applicable for the programme.
– You change the programme while it operates.
• When the programme is completed.