Personalization - Electrolux WA GL6 E 101 User Manual

6 electrolux
• Incorrect option selection : if an option
which is not compatible with the set
wash programme is selected, the mes-
sage Err is displayed for a few seconds
and the yellow pilot light of button 8 light
starts blinking.
• Delay Start : the selected delay (20
hours max) set by the relevant button ap-
pears on the display for a few seconds,
then the duration of the previously selec-
ted programme is displayed. The symbol
7.3 will appear on the display. The delay
time value decreases by one unit every
hour. When only 1 hour remains, the time
decreases every minute.
7.3 Delay Start - symbol
INDICATOR PILOT LIGHTS (10)
If the OVERDOSAGE pilot light (Über-
dosiert-Surdosage) ) ( 10.1 ) illuminates

PERSONALIZATION

Acoustic signals
The machine is provided with an acoustic
device, which sounds in the following ca-
ses:
• at the end of the cycle
• in the event of operating problems.
By pressing the 3 and 4 buttons simultane-
ously for about 6 seconds, the acoustic sig-
nal is deactivated (except for the events of
operating problems). By pressing these 2
buttons again, the acoustic signal is reacti-
vated.
Child safety lock
This device permits you to leave the appli-
ance unattended and not to worry that chil-
7.4 Programme progress display : the
display shows the different washing pro-
gramme phases. After the appliance starts
operating, the display show the relevant
symbol of the washing phase which is run-
ning: = WASHING,
= DRAINING, = SPINNING - symbols
7.5 Door lock symbol
This symbol indicates if the door can be
opened:
• symbol on: the door cannot be opened.
The appliance is running or the appliance
has stopped with water left in the tub.
• symbol off: the door can be opened. The
washing programme is finished.
at the end of the programme, it indi-
cates that too much detergent has
been used.
When the appliance is performing additional
rinses the EXTRA RINSE pilot light ( 10.2 )
illuminates. To add an additional rinse,
please see chapter «Select an additional
rinse».
dren might be injured by or cause damage
to the appliance.
This function remains able also when the
washing machine is not working.
There are two different ways to set this op-
tion:
• Before pressing button 8 : it will be im-
possible to start the machine.
• after pressing button 8 : it will be impos-
sible to change any other programme or
option.
To enable or disable this option press si-
multaneously for about 6 seconds buttons
4 and 5 until the symbol 7.1 appears or dis-
appears on or from the display.
= RINSING,