Setting The Amount Of Rinse Aid Required; Activating/Deactivating The Inflow Of Rinse Aid - AEG FAVORIT 88070 Vi User Information

Setting the Amount of Rinse Aid Required

3
Only change the amount dispensed, if smears, milky spots (reduce the
amount) or dried on water spots (increase the amount) can be seen on
glasses and dishes. (See section "If dishwashing results are not satisfac-
tory".) The dosage can be set from 1-6. The dosage is pre-set to "4" in
the factory.
1. Open the dishwasher door.
2. Press the release button on the rinse
aid compartment.
3. Open the cover.
4. Set the dosage level.
5. Press the lid shut until it clicks into
place.
6. If rinse aid has leaked out, wipe it
away with a cloth.

Activating/Deactivating the Inflow of Rinse Aid

When the 3 IN 1 option is activated, you do not need to deactivate the
rinse aid inflow.
1. Press the ON/OFF button.
3
If the name of a stage of a cycle is shown on the display, this means a
rinsing cycle is active. You must first of all cancel the rinsing cycle:
– Press the RESET key combination.
The display will read CONFIRM CANCEL?
– Press the OK/START button. This will cancel the rinsing cycle.
2. Go to the RINSE AID setting; see the section "Adapting an option/set-
ting".
3. If required, set the right value.
If the value is ON, the rinse aid inflow is activated; if the value is OFF, it
is deactivated.
16