Before Use; Protect The Ceramic Hob; Clean The Burners - AEG FM 7300G-an Instruction Book

Mounting:
When mounting several hobs together you must use a reinforcement beam
between each hob as well as the silicone supplied with the hobs (see fig.)
1. Cut a hole of the calculated size in the table top
2. Place the individual hobs upside down on a mat. Take care that the top side is
not scratched.
3. Mount the clamping fittings in the holes in the side of the base panels (see
fig.)
4. Place the first hob in the hole.
5. Apply silicone to the two corners joining the next hob (see fig.)
Use only the silicone supplied with the hobs as this is intended to tolerate the
high temperatures of the appliance.
6. Push a reinforcement beam up against the hob. Apply silicone on the rein-
forcement beam (see fig.)
7. Tighten the clamping fittings to the table top using a screwdriver.
8. Repeat the process for the other hobs.
Silicone
24

Before Use

Protect the ceramic hob

Before using the product for the first
time, clean off any factory residues
such as dust or dirt. Give the ceramic
hob a protective coating before using
it. This will make it easier to clean the
hob and will prevent spills etc. burn-
ing on too hard.
This is what you do:
1. Remove the pan support(s), burner
ring and burner cover.
2. Sprinkle a few drops of a ceramic
cleaning agent onto a piece of
kitchen paper and rub into the
whole surface.
3. Polish the hob with a clean cloth
until dry.

Clean the burners

Wash the pan stands, burner covers
and burner rings in hot water and
washing-up liquid.
9