Water Drainage - AEG Automatic Installation And Connection Instructions

Water Drainage

The appliance drain hose should hook into a standpipe, the hook in the
drain hose is formed using the plastic "U-Piece" supplied, with an
internal diameter of approximately 38 mm (see diagram) thus ensuring
there is an air break between the drain hose and standpipe.
When discharging into a stand-
pipe ensure that the top of the
curve in the hose end is no more
that 90 cm (35.4'') and no less
than 60 cm (23.6'') above floor
level.
The upright standpipe should
have a minimum, length of
30 cm (12'') from the bottom of
the elbow to the top of the pipe
(see diagram). Make sure that it
is designed in such a way that
the end of the drain hose
cannot be covered with water.
Longer drain hoses are available
in lengths of 2.7 and 4 metres
from your AEG Service Force
Centre.
If you intend the drain hose
from the washing machine to
empty into a sink, make sure
that the sink is empty and the
plug hose is not blocked. Use
the plastic "U-Piece" supplied.
Water Connection
1
38mm (1 / ")
2
diameter standpipe
25