Table of Contents
Advertisement
Malfunction
2 short warning tones
continuously repeated can
be heard.
The cycle indicator for the
selected dishwashing cycle
is flashing,
Å 20
fault code
is dis-
played in the multi-dis-
play. (Problems with water
outflow)
3 short warning tones
continuously repeated can
be heard,
Å 30
Fault code
is dis-
played in the multi-dis-
play.
The cycle is not starting.
Rust spots are visible in
the dishwashing compart-
ment.
A whistling noise can be
heard when washing dish-
es.
Possible cause
The sink spigot connection
is blocked.
Water drain hose
has not been correctly posi-
tioned.
The anti-flood system has
been triggered.
The mains plug is not
plugged in.
A fuse in the house's wiring
system is defective.
For dishwasher models with
a delay start timer:
A start time has been se-
lected.
The dishwashing compart-
ment is made from rust-
free stainless steel. Rust
spots in the dishwashing
compartment are due to
rust particles from external
sources (rust particles from
water pipes, pans, cutlery,
etc.). Remove such spots
with a commercially-avail-
able cleaning product for
stainless steel.
The whistling is not a cause
for concern.
Remedy
Clean the sink spigot outlet.
Check the position of the
hose.
First shut off the water tap,
then switch off the appli-
ance and contact your local
Service Force Centre.
Plug in mains plug.
Replace fuse.
If the dishes are to be
washed immediately, cancel
the delay start.
Only wash cutlery, dishes
and pans that are suitable
for dishwasher use.
Decalcify appliance with
commercially available
agents for cleaning dish-
washers.
If the noises can still be
heard after decalcifying the
machine, use a different
brand of detergent for
washing cutlery and dishes.
33
Advertisement
Table of Contents
