• A qualified and competent person must do the Contact your local Customer Care Centre. plumbing installation. • Do not drill into the sides of the appliance otherwise • Do not change the specifications or modify this prod- damage to hydraulic and electrical components may uct.
Washing programmes Program Degree of soil Type of load Program description Pots Heavy soil Crockery, cutlery, Prewash pots and pans Main wash up to 70°C 2 intermediate rinses Final rinse Drying Regular Plus Normal soil Crockery and cutlery Prewash Main wash up to 65°C 2 intermediate rinses Final rinse Drying...
3. Set the correct washing program for the type of 5. Start the washing program. load and soil. 4. Fill the detergent dispenser with the correct quan- tity of detergent. Use of rinse aid Caution! Only use rinse aid specified for Caution! Do not fill the rinse aid dispenser with dishwashers.
Page 6
• While you load cutlery and dishes, do these steps: Use the cutlery grid for best washing results. If the di- mensions of the cutlery prevent use of the cutlery grid, – Load hollow items (e.g. cups, glasses and pans) remove it.
4. Replace the front runner stops (A) in their initial Caution! If the basket is in the upper position, position. do not put cups on the cup racks. Use of detergent Only use detergents (powder, liquid or tablet) that Different brands of detergent dissolve in different are suitable for dishwashers.
Select and start a washing program Do these steps to set and start a washing program: Fill the detergent dispenser with detergent before you set a new washing program. 1. Close the door. 2. Turn the program knob to set the washing program. Interrupting a washing program Refer to the chapter 'Washing programs'.
tergents. Do not use abrasive products, scouring pads or solvents (acetone etc.). Internal cleaning Do an inspection at intervals of 3 months. Set a washing program for heavily soiled dishes. Use detergent, but do not put dishes in the appliance. Long periods of non-operation Do these steps when you do not use the appliance for a long period:...
Page 10
Fault code and malfunction Possible cause and solution • continuous flash of the start/cancel • The water tap is blocked or furred with limescale. indicator light Clean the water tap. • 1 flash of the 'Finished' indicator light • The water tap is closed. The appliance does not fill with water Open the water tap.
The cleaning results are not satisfactory There are streaks, milky spots or • Decrease the rinse aid dosage. a bluish coating on glasses and dishes Dry water drop stains on glasses • Increase rinse aid dosage. and dishes • The detergent can be the cause. Technical data Dimensions Width (mm)
The drain hose can be lengthened using additional lengths and connectors. These must be purchased Caution! Always use new hoses when you from Electrolux Spare Parts. The extension length must connect the appliance to the water mains. Old not exceed 2 metres.
Warranty (NZ) Limited in respect of Appliances pur- chased in New Zealand; – 'Appliance' means any Electrolux product pur- FOR SALES IN AUSTRALIA AND NEW ZEALAND chased by you accompanied by this document; This document sets out the terms and conditions –...
Page 14
To the extent permitted by law, the lia- a claim under this warranty. bility of Electrolux (if any) arising out of or in rela- You may not make a claim under this warranty tion to the Appliance or any services supplied by...
Page 15
– in the case of services, at its option, to the sup- its Authorised Service Centres to exchange information ply of the services again or the payment of the in relation to you to enable Electrolux to meet its obli- cost of having the services re-supplied; gations under this warranty.