AEG FAVORIT 55030 User Manual page 19

WARNING!
Deactivate the appliance before you do the checks.
Malfunction
The appliance does not fill with
water.
The appliance does not drain
the water.
The anti-flood device is on.
The start of the washing pro-
gramme does not occur.
After the check, set the programme knob on the same washing programme before the mal-
function occurred. The programme continues from the point of interruption.
If the malfunction occurs again, contact the service centre.
If the display shows other alarm codes, contact the service centre.
The necessary information for the service centre is on the rating plate.
Record this information:
– Model (MOD.) ........................................................
Possible cause
The water tap is blocked or
there is limescale on it.
The water pressure is too low.
The water tap is closed.
The filter in the water inlet
hose is blocked.
The connection of the water
inlet hose is not correct.
The water inlet hose is dam-
aged.
There is a blockage in the sink
spigot.
The connection of the water
drain hose is not correct.
The water drain hose is dam-
aged.
The appliance door is open.
You did not press the Start
touchpad or button.
The mains plug is not connec-
ted in the mains socket.
The fuse in the fuse box is
damaged.
The delay start is set.
What to do if...
Possible solution
Clean the water tap.
Contact your local water au-
thority.
Open the water tap.
Clean the filter.
Make sure that the connection
is correct.
Make sure that the water inlet
hose has no damages.
Clean the sink spigot.
Make sure that the connection
is correct.
Make sure that the water drain
hose has no damages.
Close the water tap and con-
tact the service centre.
Close the appliance door.
Press the Start touchpad or
button.
Connect the mains plug.
Replace the fuse.
• Cancel the delay start.
• When the countdown is
completed, the washing pro-
gramme starts automatical-
ly.
19