Mud Buddy 2004 HyperDrive Owner's Manual

Mud motor

Table of Contents

Download this manual

Owner's Manual

installing your motor. Check the crate and engine for

damage. Call Mud Buddy and the shipping company

immediately if you find any damage or missing items.

Notice: Engine is shipped without oil. Fill before starting.

Check the oil with engine in level position. Use a good grade of

SAE 10W-30 oil. You may also use a synthetic blend oil.

Vanguard 29 and 31- takes up to 2 qt. (check after adding 1.5 qt.)

18-29 h.p. Kawi - takes up to 1.4 qt. (check after adding 1 qt.)

Your engine is equipped with a mercury safety switch which prevents the engine from being

started unless the propeller is raised and out of the water.

Kawasaki 29 EFI Notice: Fuel injection system. When new or when in storage for an extended

period, bleed the fuel line of air. Remove the fuel line above the fuel filter, turn the key on and

pump out 1/4 cup of fuel into a suitable container. Reassemble. The fuel filter may have a little

air inside, this is okay. If you run out of fuel the above procedure must be repeated.

Mud Buddy

HyperDrive

Thank you for purchasing the most advanced

mud motor in the world.

Assembly - Read the instructions inside before

Kawasaki Notice

2004

Engines

Table of Contents

Need help?

Do you have a question about the 2004 HyperDrive and is the answer not in the manual?

Page 1 Assembly - Read the instructions inside before installing your motor. Check the crate and engine for damage. Call Mud Buddy and the shipping company immediately if you find any damage or missing items. Notice: Engine is shipped without oil. Fill before starting.
Page 2 Warranty does not cover propeller and belt wear. Warranty does not cover lack of - The Mud Buddy can be operated from the siting position. If you lubrication, abuse or mistreatment. stand, use a stand-up bar or some other steady-hold to maintain your balance.
Page 3 Tighten the nuts enough for good mounting, but not - Start off slowly and soon you will learn new ways of using the Mud Buddy to so tight that the handle does not tilt up and down.
Page 4: Propeller Installation
Your user name is outdoor and password is fun. All lower case. add a long piece of tube or pipe to the wrench for leverage. Use a Mud Buddy Check the web page often for product updates, service tips and more prop wrench, to unscrew the propeller.
Page 5 - Clean, then place a small bead of silicone on the top access cover and re- install. Tiger Propellers 18-35 horse 11 X 10 Tiger 14 horse 10 X 8 Tiger Mud Buddy Manufacturing 7956 South 1530 West West Jordan, Utah 84088 Sales and Service 801.351.8011 Fax 801.561.3799 www.mudbuddy.com email info@mudbuddy.com Check the web page often for updates, service tips and more.