49-537.fm Page 22 Thursday, August 19, 1999 9:16 AM
PROBLEM SOLVING
If you have problems, these suggestions might
help.
Keypad does not arm or disarm your system.
•
Be sure all connections are correct.
•
Check for the proper setting of
•
The security code resets to the preset factory
code (1 2 3 4) if power has been disconnected.
You cannot remember your code.
•
Temporarily disconnect power to reset to the
factory code (1 2 3 4).
Note: If your system has battery back-up, you
must also disconnect the battery.
You cannot silence the alarm from the keypad
after activating the panic circuit.
•
Your alarm system is not equipped for this fea-
ture. Reset the alarm from the alarm system.
22
.
LATCH IN/OUT