Mounting Instructions - OEM IW-SYS3 Owner's Manual

Mounting Instructions

CAUTION
The IW-SYS3 should not be
installed in an exterior wall.
1. The IW-SYS3 should only be installed in an interior wall. Use a "stud finder" to locate the positions
of the studs.
2. Assess the wall area for possible concealed obstructions such as wiring, plumbing, heating ducts,
etc. These might be used in adjacent rooms or on other floors in multi-level homes.
3. Inspect the backside of the wall, the attic, and/or the crawl space if available for clues to possible
obstructions. Use inspection holes with inspection tools (camera, mirror, flashlight, etc.) if
necessary.
4. Use the Mounting Dimensions provided to mark the location of the cut-out, ensuring that it is level.
5. Using the proper tool, cut the appropriate sized hole in the wall. On drywall, clean cuts can be made
with a drywall saw.
6. If the wiring has not yet been run, do so now that you have access to the wall's interior.
7. Mark the 4 attachment holes and pre-drill them. 7/64" (2.8mm) is the suggested drill bit diameter.
These holes can be measured and marked per the dimensions but it is also possible to mark them
using the IW-SYS3. To do it this way, position the IW-SYS3 on the wall in the hole that was cut while
ensuring that the unit is level and resting near the bottom of the hole. Mark the mounting holes with
a scribe or slender screwdriver. The marking tool should be inserted through the 4 holes in the front
of the unit.
8. Make the the audio output and antenna connections as shown on the previous pages and the AC
electrical connections as shown on the following pages.
9. Screw the IW-SYS3 to the wall using the 4 screws that are provided.
10. Install the 4 screw caps to cover the mounting holes.
IW-SYS3:
In-Wall Audio System
26
!
Rev. C
AM / FM / CD / AUX / USB AM / FM / CD / AUX / USB