Gigabyte GA-K8N51GMF-9-RH User Manual page 65

CMOS Setup Utility-Copyright (C) 1984-2006 Award Software
SATAII RAID Config
On-Chip IDE Channel0
On-Chip IDE Channel1
IDE1 Conductor Cable
IDE2 Conductor Cable
Serial-ATA-II 1
Serial-ATA-II 2
On-Chip USB
USB Keyboard Support
USB Mouse Support
Onboard Audio Function
Onboard LAN Function
Onboard LAN Boot ROM
Onboard 1394 Function
Onboard Serial Port 1
Onboard Parallel Port
Parallel Port Mode
: Move Enter: Select
F5: Previous Values
In the SATAII RAID Config submenu, enable SATA-II RAID function. Then enable the SATA ports
with hard disks that you want to use for RAID. In the example in Figure 2, enable SATA-II 1 Primary/
Secondary RAID or SATA-II 2 Primary/Secondary RAID). (For example, if you wish to create RAID
with hard disks on the SATAII0 and SATAII1 connectors, set SATA-II 1 Primary/Secondary RAID to
Enabled).
CMOS Setup Utility-Copyright (C) 1984-2006 Award Software
SATA-II RAID function
x SATA-II 1 Primary RAID
x SATA-II 1 Secondary RAID
x SATA-II 2 Primary RAID
x SATA-II 2 Secondary RAID
: Move Enter: Select
F5: Previous Values
The BIOS Setup menus described in this section may not show the exact settings for your
motherboard. The actual BIOS Setup menu options you will see shall depend on the motherboard
you have and the BIOS version.
Integrated Peripherals
[Press Enter]
[Enabled]
[Enabled]
[Auto]
[Auto]
[Enabled]
[Enabled]
[V1.1+V2.0]
[Disabled]
[Disabled]
[Auto]
[Auto]
[Disabled]
[Enabled]
[3F8/IRQ4]
[378/IRQ7]
[SPP]
+/-/PU/PD: Value F10: Save
F6: Fail-Safe Defaults
Figure 1
SATAII RAID Config
[Disabled]
Disabled
Disabled
Disabled
Disabled
+/-/PU/PD: Value F10: Save
F6: Fail-Safe Defaults
Figure 2
- 65 -
Item Help
Menu Level
ESC: Exit F1: General Help
F7: Optimized Defaults
Item Help
Menu Level
ESC: Exit F1: General Help
F7: Optimized Defaults
Appendix