Panel Controls; Operating Instructions - Danby DDR2611 Owner's Use And Care Manual

Operating Instructions

CONTROL PANEL
INSTRUCTIONS
CONTROLS
When you push the button to change operation
modes, the unit will make a beeping sound to indicate
that it is changing modes.
1) FAN BUTTON
Control the fan speed. Press to select either High or
Normal fan speed. Set the fan control to High for
maximum moisture removal. When the humidity has
been reduced and quiet operation is preferred, set the
fan control to Normal.
2,4) ( + / - ) buttons
Humidity Set Control Pads
The humidity level can be set within a range of
35%RH(Relative Humidity) to 85%RH(Relative
Humidity) in 5% increments.
NOTE: The control panel of the unit you purchased may be slightly
different according to the models.
Auto start
indicator light
Low fan
High fan
indicator light
indicator light
1 2
Auto stop
indicator light
7
Bucket full
indicator light
1 2 3 4 5 6
5
• For drier air, press the (-) button and set to a lower
percent value(%).
• For damper air, press the (+) button and set a higher
percent value(%).
Timer Set Control Buttons
Use the (+ -) / buttons to set the Auto start and
Auto stop time from 0.0 to 24.
3) Timer Button
Press to initiate the Auto start and Auto stop feature, in
conjuction with the (+) and (-) keys.
5) Continue Button
Press to activate the continuous dehumidifying operation
and dehumidifying operation.
5
Continuous
Power on
operation on
indicator light
indicator light
7