ADT SECURITY MANAGER 2000 User Manual page 30

TROUBLE CONDITIONS (Continued)
Words or letters in parentheses (
Touchpads .
Other Trouble
1. COMM. FAILURE
Displays
*
Any ÒbeepingÓ that
2. SYSTEM LO BAT
accompanies a
trouble display can be
stopped by depress-
ing any key on the
touchpad or by
3. LO BAT + zone descriptor
entering an OFF
sequence (code +
OFF)
**
Not all systems use
Ê
wireless sensors.
4. Rcvr Jam
5. MODEM COMM
6. BELL FAILURE
m
(or FC)
(or BAT with no zone No.)
(or BAT with zone No.)
(or CHECK 90)
(or CC)
(or CHECK 70)
Ð 30 Ð
) are those that are displayed on English Display
Indicates that a failure has occurred in the telephone com-
munication portion of your system.
CALL FOR SERVICE IMMEDIATELY.
Indicates that a low system battery condition exists. Display
is accompanied by "beeping"* at the Touchpad. If this
condition persists for more than one day (with AC present),
CALL FOR SERVICE.
Indicates that there is a low battery condition in the wireless
transmitter** number displayed. Accompanied by a single
"beep" * (once every 40 seconds) at the Touchpad.
Either replace the battery yourself, or CALL FOR SERVICE.
If the battery is not replaced within 30 days, a C H EC K
display may occur.
Wireless part of the system is experiencing RF interference
which may impede reception from wireless sensors.**
Indicates that the control is on-line with the Customer Care
Center's remote computer. The control will not operate
while on-line. Wait a few minutes. Display should disappear.
Indicates that the wiring connection to the external sounder
is at fault (open or shorted). Accompanied by ÒbeepingÓ at
the touchpad. CALL FOR SERVICE IMMEDIATELY.