Filtration Unit Installation - Delta 210 Series Owner's Manual

D.
1.1" (28 mm)
Minimum
Hole Size
Feed tubes down through hole in sink
D.
making sure that the gasket is properly
aligned in cavity of base. Install
mounting bracket (1) & nut (2).
Tighten with the provided wrench (3).
NOTE: The wrench provided is
designed to be used with a variety of
tools: flat/phillips head screwdrivers,
wrenches, etc.
4 1-800-345-DELTA (3358)
www.deltafaucet.com
2
IMPORTANT:
Connect to
the cold water
supply ONLY.
1
2
3
5

Filtration Unit Installation

Decide on the placement of the
A.
mounting bracket (1) within a 25"
maximum distance from the quick
connect spout nipple (2). Allow a
minimum of 5" from the bottom of
the mounting surface (3) and a 10"
minimum from the bottom of the
cabinet (4). Mark the positions of
the two mounting bracket holes (5).
If plastic anchors are needed, drill
two 1/4" (6 mm) holes (6) and insert
the anchors (7). Install the bracket
using the two screws enclosed (8).
A.
25" (635 mm)
2
1
10" (254 mm)
Min. From Bottom of Cabinet
7
5
8
5" (127 mm)
Min. From
Bottom of
Mounting
Surface
Maximum
3
4
6
2.5"
(63.5 mm)