Harman Kardon AVR 310 Owner's Manual page 33

Advanced Features
turned off, the semi-OSD displays will remain
activated, even if they were switched off for the
previous listening session.
To change the length of time that the semi-OSD
displays remain on the screen, go to the
ADVANCED SELECT Menu as outlined
buttons n as
earlier, and press the
/
⁄ ¤
needed, until the on-screen › cursor is next to
the SEMI-OSD TIME OUT line. Next,
press the ‹ › Buttons o until the
/ 31
desired time in seconds is displayed. Note that
unlike most of the other options in this menu,
this is a permanent setting change, and the
time-out entry will remain in effect until it is
changed, even when the unit is turned off.
If you wish to make other adjustments, press
Buttons n until the on-screen
the
/
⁄ ¤
cursor is next to the desired setting or the
RETURN TO MAIN MENU line and
press the Set button p. If you have no other
adjustments to make, press the OSD Button
v to exit the menu system.
Full-OSD Time Out Adjustment
The FULL-OSD menu system is used to
simplify the setup and adjustment of the
AVR 310 using a series of on-screen menus. The
factory default setting for these menus leaves
them on the screen for 20 seconds after a
period of inactivity before they disappear from
the screen or Time Out. This Time Out is a safety
measure to prevent image retention of the
menu text in your monitor or projector, which
might happen if they were left on indefinitely.
However, some viewers may prefer a slightly
longer or shorter period before the Time Out
display.
To change the Full-OSD Time Out, you will need
to make an adjustment in the ADVANCED
SELECT menu (Figure 9). To start the
adjustment, press the OSD button v to bring
the main AUDIO SETUP menu to the
button n six times,
screen. Press the
¤
until the on-screen cursor is next to the
¤
ADVANCED line. Press the Set Button p
to enter the ADVANCED SELECT Menu
(Figure 9).
At the ADVANCED SELECT menu
(Figure 9) make certain that the on-screen
cursor is next to the FULL-OSD TIME
Buttons n as
OUT line by pressing the
/
⁄ ¤
buttons o/
needed. Next, press the ‹ ›
/
until the desired time is displayed in seconds.
Note that unlike most of the other options in
this menu, this is a permanent setting change,
and the Time-Out entry will remain in effect
until it is changed, even if the unit is turned off.
If you wish to make other adjustments, press
Buttons n until the on-screen
the
/
⁄ ¤
cursor is next to the desired setting or the
RETURN TO MAIN MENU line and
press the Set button p. If you have no other
adjustments to make, press the OSD
button v to exit the menu system.
›
›
31
›
33 ADVANCED FEATURES