WARNINGS It is most important that this instruction book The inner lining of the appliance consists of chan- should be retained with the appliance for future nels through which the refrigerant passes. If these reference. Should the appliance be sold or trans- should be punctured this would damage the appli- ferred to another owner, or should you move ance beyond repair and cause food loss.
INSTALLATION If this refrigerator featuring magnetic door seals is The manufacturer declines to accept any liability if to replace an older appliance having a spring lock this accident-prevention procedure is not followed. on the door or lid, be sure to make that spring lock This appliance complies with E.E.C.
Page 5
To ensure adequate ventilation, allow the clearances Open the door and push the appliance against the shown in figure 2. side of the kitchen unit opposite to that of appliance hinges. Fig. 2 50-min. cm Fasten the appliance with 4 screws provided in the kit included with the appliance.
Page 6
Position the runners (H) at the top and bottom of the Remove the little plates and make the holes with a di- inside of the kitchen unit as shown in Fig. 8 and mark am. of 2 mm. Replace the little plates over the runners the position of the external holes.
Starting-up and temperature regulation Food to be frozen should not be in contact with frozen foods in order to avoid an increase in temperature. Insert the plug into the wall socket. Open the refriger- ator door and turn the thermostat knob, located on Warning the upper right side of the inner liner clockwise, be- Never put fizzy drinks in the freezer as they might well...
Positioning the door shelves Hints for correct use: Raw meat (beef, pork, lamb, poultry and game): wrap To permit storage of food packages of various sizes, in polythene bags and place on top of the salad crisp- the door shelves can be adjusted in height. er and, for safety, only store in this way for one or two To make these adjustments proceed as follows: days at the most.
Fig. 16 The freezer compartment, however, will become pro- gressively covered with frost. This should be removed with the special plastic scraper provided, whenever the thickness of the frost exceeds 4 mm. During this operation it is not necessary to switch off the power supply or to remove the foodstuffs.
MAINTENANCE Replacing the interior light bulb Unplug the appliance before carrying out any maintenance operation. The light inside the refrigerator compartment is easy to get at through the opening in the light holder. Periodical cleaning If the light does not go on when the door is open, check that it is screwed into place properly.
Need help?
Do you have a question about the FC260I and is the answer not in the manual?
Questions and answers