Panasonic TH-42LF30ER Operating Instructions Manual page 44

Options Adjustments
Item
Off
You can set the power-on delay time of the displays to reduce the power load, when you press
turn on the multiple displays that are set together, for example, on MULTI DISPLAY system.
Set each display's setting individually.
Off:
Power ON Screen
1 to 30 (sec.): Set the power-on delay time (second).
Delay
Notes:
• During this function is working, the power indicator is blinking green.
• This function also works when the power recovers from failure or after plugging off and in again the
power cord.
Off: Not display the clock.
On: Display the clock.
The clock is displayed at the lower left of the screen when
Clock Display
Whether to show/hide No activity power off Precautions at the time of power ON is set.
Power On Message
On: The warning precautions are shown at the time of power ON.
(No activity power
Off: The warning precautions are not shown at the time of power ON.
off)
Note: This setting is enabled only if "No activity power off" is "Enable" (see page 31).
Set the functions that operates when
Signal: The "Signal" menu is displayed.
Screensaver: The "Screensaver" menu is displayed.
ECO menu: The "ECO Mode settings" menu is displayed.
Set up TIMER: The "Set up TIMER" menu is displayed.
Note:
Factory settings are as follows.
FUNCTION1 button: Signal
FUNCTION2 button: Screensaver
Function button assign 1
Function button assign 2
Use the FUNCTION button
Normalisation
When both main unit buttons and remote control are disabled due to the "Button lock", "Remocon User level" or
"Remote ID" adjustments, set all the values "Off" so that all the buttons are enabled again.
Press the button on main unit together with
"Shipping" menu is displayed and the lock is released when it disappears.
44
1 2 3.... 30
The display will be turned on at the same time as
After pressing , the display will be powered on with time delay depending on this setting.
Note: When "PRESENT TIME Setup" is not set, the clock is not displayed even
if "Clock Display" is "On". (see page 27)
10:00
The menu screen is displayed. (Example: Signal)
Signal
3D Y/C Filter
Colour system
Cinema reality
Noise reduction
Press the FUNCTION button to exit from the menu.
button on the remote control and hold for more than 5 seconds. The
Adjustments
is pressed.
button is pressed.
is pressed.
[ AV ]
On
Auto
Off
Off
to