Rear Panel - Ovislink AirLive WL-5400CAM User Manual

Rear Panel

②
External Antenna
③
Reset Button
① ④
DC Power Connector
Network Cable Connector
1. Network Cable Connector
The Wireless Internet Camera's rear panel features an RJ-45 connector for connections to 10Base-T Ethernet
cabling or 100Base-TX Fast Ethernet cabling (which should be Category 5 twisted-pair cable). The port supports
the N-Way protocol and "Auto-MDIX" function, allowing the Wireless Internet Camera to automatically detect or
negotiate the transmission speed of the network.
2. External Antenna
The rotatable external antenna allows you to adjust its position to obtain the maximum signal.
3. Reset Button
Reset will be initiated when the reset button is pressed once, and Power LED begins to flash.
Factory Reset will be initiated when the reset button is pressed continuously for three seconds or when Power LED
begins to light up. Release the reset button and the Power LED will begin to flash, indicating the Wireless Internet
Camera is changing to factory reset. When factory reset is completed, the Wireless Internet Camera will be set to
default on channel 11 and SSID is set as "AirLive" (This default setting will let the Wireless Internet Camera
connect to ANY access point on the infrastructure network). The IP address will also return to the default setting
as 192.168.0.20.
4. DC Power Connector
The DC power input connector is located on the Wireless Internet Camera's rear panel, and is labeled DC5V with a
single jack socket to supply power to the Wireless Internet Camera. Power will be generated when the power
supply is connected to a wall outlet.
7 AirLive WL-5400CAM User's Manual