Output) Limiter; Output) Delay; D.6 (Output) Limiter; D.7 (Output) Delay - CARVIN XDrive DCM2000Lx Operation Manual

BUTTER 12 : Butterworth 12db/octave slope (2
BUTTER 18 : Butterworth 18db/octave slope (3
BUTTER 24 : Butterworth 24db/octave slope (4
BUTTER 48 : Butterworth 48db/octave slope (8
BESSEL 12, or 24: Bessel (2
LINKWZ 12, 24, or 48: Linkwitz-Riley (2

4.D.6 (OUTPUT) LIMITER

The Limiter is used to protect amplifiers and speakers by controlling peaks in
the amplifier output which could otherwise cause distortion or clipping.
Thresh: The Threshold level has a range from 0dB to -30dB.
Output levels less than the Threshold setting will not be affected.
(a.) Press (A/1, B/2, C/3 or D/4) to enter OUTPUT mode (CH, Number).
(b.) Press Left or Right until the screen above is shown.
(c.) Use Up/Down to adjust the Threshold for the limiter.

4.D.7 (OUTPUT) DELAY

The Delay time can be added to an OUTPUT to time-align drivers or to
account for distance between other enclosures.
(a.) Press (A/1, B/2, C/3 or D/4) to enter OUTPUT mode (CH, Number).
(b.) Press Left or Right until the screen above is shown.
(c.) Use Left/Right to select coarse (ex. mS) or fine (ex. uS) increments.
(d.) Use Up/Down to adjust the delay time (in Seconds, Feet or Meters).
(change units in the UTILITY menu)
The total amount of delay available for the DCM-Lx is 120 milliseconds
(120ft./36.5M). Each time a delay is added, it deletes it from the total time
available for the system. For example, a Stereo setup may have up to a
maximum of 63mS for each of the 2 inputs. (see 4.B.2 for memory available)
- Continued next page with section 4.D.8 PARAMETRIC EQ's -
nd
rd
th
th
nd th
order) or (4 order)
nd
order), (4
Example: Output 1
Threshold = -3dB
15
order)
order)
order)
order)
th th
order), (8 order)