SoundCraft EFX12 User Manual page 9

10 PFL
11 PEAK LED
12 INPUT CHANNEL FADER
13 MIX OUTPUTS (XLR) & MONO OUT (¼" Jack) Connect these to your analogue recording device, or to
14 MIX INSERTS (¼" Jack)
15 MONITOR O/Ps (¼" Jack) These are used to feed your monitoring system. This can be directly con-
16 MASTER FADERS
17 MAIN METERS
18 MONITOR CONTROL
19 PHONES CONTROL
20 AUX 1 OUTPUT (¼" Jack) This output can be used to send the channel signal to an artist's monitors
21 AUX CONTROL
22 STEREO INPUTS (¼" Jack) These two inputs can be used to connect line level stereo inputs from key-
23 2-TRACK INPUTS (RCA Phono)
24 2-TRACK CONTROLS
25 RECORD OUTPUTS (RCA Phono) You can connect these to the inputs of your recording device.
26 PHANTOM POWER
27 HEADPHONES (¼" Jack)
28 STEREO RETURN INPUTS
29 STEREO RETURN CONTROL This control sets the level of signal routed to the main mix busses. There is
30 FX BUS OUTPUT
31 FOOTSWITCH CONNECTOR This is used by the FX Processor, see page 23.
32 LEXICON® FX PROCESSOR See the information starting on page 22.
When pressed the signal will appear on the monitor and headphone outputs
- use this to monitor the post-EQ signal from the channel.
This is used to indicate that the signal is close to distorting (clipping) on a
specific channel.
This is used to control the level fed to the Mix Bus and post-fade sends.
your amplification system.
This is a pre-fade break in the signal path which can be used to feed a
dynamics or mastering device. The signal is sent from the tip of the jack plug
and the return path comes back in on the ring of the jack plug.
nected to powered monitors, or indirectly via an amplifier to standard moni-
tors.
These faders control the overall level of the mix outputs.
These show the level of the mix outputs. When the PFL ACTIVE LED is lit, the
meters show the level of the selected PFL signal.
This controls the level of the signal sent to your monitoring system.
This controls the level of the signal sent to the headphones jack socket.
(headphones/in-ear/stage monitors). It is switchable pre/post fade.
This switch globally switches the AUX1 feed on all the input modules to be
either pre or post-fade.
boards, sound modules, samplers, computer based audio cards etc. These
inputs pass through a normal channel strip, with EQ, Auxes and a Balance
control.
Here you can connect the playback from your recording device.
Use these to control the 2 Track signal. The MONITOR switch sends the signal
to the monitor outputs and phones, whilst the TO MIX switch sends it to the
main mix.
Press this to switch the phantom power (48V) on for condenser microphones.
WARNING: Do Not apply Phantom Power before connecting a microphone.
Plug your headphones into this socket. Recommended headphones imped-
ance is 150 ohms or greater.
This pair of inputs accept 3-pole ' A ' gauge (TRS) jacks. Use these inputs for
sources such as keyboards, drum machines, synths or CDs. The inputs are
BALANCED. Mono sources may be used by plugging into the left jack only.
an associated PK LED to warn of signals which are too high.
This output carries the signal from the FX bus. It could be used as a second
Aux Output if desired, if the FX Processor is not needed at the time. The FX
sends on the inputs channels to the FX bus are always post-fade.
9