Fx Processor Controls - SoundCraft EFX12 User Manual

FX PROCESSOR CONTROLS

1. Tempo Button - Tapping this button twice sets the Delay Time of the selected
program. The LED flashes to indicate current tempo. Can be tapped in time with
music source to synchronise the delay.
2. Store Button - Stores program modifications to one of the program locations.
Press and hold for three seconds will store the preset in the current location. The
LED will flash rapidly during the store operation and then stay illuminated for 1
second to show the operation is complete.
3. Pre Delay / Time/ Speed Knob - Controls Pre Delay of the reverbs or the first
parameter (time or speed related) of the selected effect. The LED illuminates when
the parameter matches the stored setting.
4. Decay / Feedback/Depth Knob - Controls Decay of the reverbs or the second
parameter (feedback or depth related) of the selected effect. The LED illuminates
when the parameter matches the stored setting.
5. Variation - Controls Liveliness or Diffusion (depending on the reverb selected) or
the third parameter of the selected effect. The LED illuminates when the parameter
matches the stored setting.
6. Program Select Knob - Navigates through programs, turning to the required pro-
gram will initiate the loading of the program which take approximately 1 second. The
knob can be rotated clockwise or anticlockwise and will alternate between BANK A
and BANK B every full rotation. The current bank is shown by its illuminated LED,
which flashes if the FX processor is muted. There is a handy aide memoir of the
programs printed on the front panel.
7. Clip LED – This LED illuminates when either the incoming audio or the processed
audio (within the effect processor) overloads, and causes distortion of the signal.
Footswitch Input (see diagram on page 20) - Using a single-pole, momentary
footswitch inserted into the FOOTSWITCH input the effects processor can be muted/
un-muted.
8. PFL - This switch routes a post effects processor, pre-fade (EFFECTS FADER) sig-
nal to the monitor system.
9. MUTE - This switch mutes the output of the FX processor. It doesn't mute the PFL
signal or the FX TO AUX 1 pre-fade signal.
10. FX TO AUX 1 - This pot routes a pre-fade and a post-fade signal to the Aux 1-pre and Aux 1-post busses
respectively.
11. EFFECTS FADER - This fader controls the level of the signal, from the FX processor, routed to the main mix
busses.
FX BUS OUT (see diagram on page 20) - This output carries the signal from the FX bus. It could be used as
a second Aux Output if desired, if the FX Processor is not needed at the time.
23