Asus CUSL2-C User Manual page 41

3. HARDWARE SETUP
22) ATX Power Supply Connector (20-pin block ATXPWR)
This connector connects to an ATX power supply. The plug from the power sup-
ply will only insert in one orientation because of the different hole sizes. Find the
proper orientation and push down firmly making sure that the pins are aligned.
IMPORTANT: Make sure that your ATX power supply (minimum recommended
wattage: 200 watts; 235W for a fully-configured system) can supply at least 20
amperes on the +5-volt lead and at least 10mA (750mA recommended) on the +5-
volt standby lead (+5VSB). Your system may become unstable/unreliable and may
experience difficulty in powering up if your power supply is inadequate. For Wake-
On-LAN support, your ATX power supply must supply at least 750mA +5VSB.
®
CUSL2-C
CUSL2-C ATX Power Connector
23) Power Supply Thermal Sensor Connector (2-pin JTPWR)
If you have a power supply with thermal monitoring, connect its thermal sensor
cable to this connector.
®
CUSL2-C
CUSL2-C Thermal Sensor Connector
ASUS CUSL2-C User's Manual
+3.3 Volts +3.3 Volts
+3.3 Volts
-12.0 Volts
Ground
Ground
+5.0 Volts
Power Supply On
Ground
Ground
+5.0 Volts
Ground
Ground
Ground
Power Good
-5.0 Volts
+5V Standby
+5.0 Volts
+12.0 Volts
+5.0 Volts
JTPWR
Power Supply
Thermal Sensor
41