Snapping Events; The Event List; Editing The List - Lexicon 300 Owner's Manual

300 "3.0
Owner's
Manual Lexicon
Snapping evenis The easiest way to develop a list in the 300 is to "SNAP" entries into the list. To
use the snap function, select OFF and turn the Soft knob to enable time code
(ON). Locate the source machine to the beginning of the section you want to
experiment with. Give yourself about a 5 second preroil and '?oli tape". Now,
press SNAP. The display should show rolling time code.
The number displayed in the upper left portion of the display indicates the event
number which you are about to snap. Simply press the key directly below
"SNAP" wherever you want effect changes to happen. This will assign those
time code addresses to the Event List.
The upper right portion of the display shows running time code. The lower line
of the display shows the time code of the most recently snapped entry, and
allows you to clear the most recently snapped time code.
Xme code formats are indicted as follows:
SV valid SMPTE Non-Drop
SDVvalid SMPTE Drop Frame
E-V valid EBU
F-V valid Film
V indicates valid time code
Editing the Event List Editing the list includes trimming snapped time codes, choosing the fype of
automation change, and se/ecfing the event Ti?e
EDIT function
also allows you
to enter time code numbers directly into the list rather than'snapping them. TO
edit the event list, press the key directly below "EDIT". The display will show:
Pressing the key directly above "#Ol" allows you to use the Soft knob to sCrOtl
through the Event List to select the event number you want to edtt. You will
obviously want to starf with number one.
b-4