Setting Oven Controls - Frigidaire ES530 Use & Care Manual

Setting the Clock
The CLOCK pad is used to set the clock. The clock may be
set for 12 or 24 hour time of day operation. The clock has been
preset at the factory for the 12 hour operation. When the appliance
is first plugged in, or when the power supply to the appliance has
been interrupted, the clock in the display will flash (See Fig. 1).
INSTRUCTIONS
To set the clock (example below for 1:30):
1. Press . "CLO" will appear in the display (See Fig. 2).
2. Press
Fig. 3). Press . "CLO" will disappear and the clock will start
(See Fig. 4).
Changing between 12 or 24 hour time of day display:
1. Press and hold for 6 seconds untill "12h" or "24h" appears
in the display.
2. Press to switch between the 12 and 24 hour time of day
display. "12h" or "24h" will be displayed (See Figs. 5 or 6).
3. Press to accept the desired change or press
the change.
4. Reset the correct time as described in To set the clock above.
Please note that if the 24 hour time of day mode was chosen,
the clock will now display time from 00:00 through 23:59 hours.
Setting Silent Control Operation
The DELAY START
operation feature allows the oven control to be operated without sounds or beeps whenever necessary. If desired the control
can be programmed for silent operation and later returned to operating with all the normal sounds and beeps.
INSTRUCTIONS
To change control from normal sound to silent control operation:
1. To tell if your range is set for normal or silent operation press
and hold for 6 seconds. (See Fig. 7)
2. Press to switch between normal sound operation and silent
operation mode. The display will show either "SP" (See Fig. 8)
or " - -" (See Figs. 2 or 3).
If "SP" appears (See Fig. 2), the control will operate with normal
sounds and beeps. If " - -" appears (See Fig. 9), the control is
set for silent operation mode.
3. Press to accept the change or press
change.

Setting Oven Controls

pads to set the time of day to 1:30 (See
and FLEX CLEAN
to reject
pads control the Silent Control operation feature. The Silent Control
to reject the
11
PRESS
for 6 seconds
or
PRESS
for 7seconds
or
Fig. 1
DISPLAY
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
DISPLAY
Fig. 7
Fig. 8
Fig. 9