Clock; Power Outlets - Cadillac 2014 Escalade/Escalade ESV Owner's Manual

5-6 Instruments and Controls
To calibrate the compass, use the
following procedure:
Compass Calibration Procedure
1. Before calibrating the compass,
make sure the compass zone is
set to the variance zone in which
the vehicle is located. See
Compass Variance (Zone)
Procedure earlier in this
section.
Do not operate any switches
such as window, sunroof,
climate controls, seats, etc.
during the calibration procedure.
2. Press the vehicle information
button until PRESS
CALIBRATE COMPASS
displays.
3. Press the set/reset button to
start the compass calibration.
4. The DIC will display
CALIBRATING: DRIVE IN
CIRCLES. Drive the vehicle in
tight circles at less than 8 km/h
(5 mph) to complete the
calibration. The DIC will display
CALIBRATION COMPLETE for a
few seconds when the
calibration is complete. The DIC
display will then return to the
previous menu.

Clock

Setting the Time and Date
To set the time or date:
1. Select Settings from the Home
Page, then select Time and Date
Settings.
2. Select the desired function.
3. Turn the MENU knob to increase
or decrease the value.
TO
4. Press the MENU knob to go to
the next value. After the last
value is selected the system will
update and return to the Settings
menu. Press
the last menu and save the
changes.
If auto timing is set, the time
displayed on the clock may not
update immediately when driving
into a new time zone.
To set the clock display:
1. Select Settings from the Home
2. Select Clock Display.
3. Turn the MENU knob to Off
4. Press the MENU knob to select.
Press
menu and save the changes.

Power Outlets

The accessory power outlets can be
used to plug in electrical equipment,
such as a cell phone or MP3 player.
BACK to go to
The vehicle has three accessory
power outlets located:
Page, then select Time and Date
Settings.
or On.
BACK to go to the last
Inside the floor console
storage bin.
On the rear of the floor console.