Electrolux EFT 540-640-740 User Manual page 19

Mounting of cooker hood between Mounting of cooker hood between Mounting of cooker hood between Mounting of cooker hood between Mounting of cooker hood between
cupboards cupboards cupboards
cupboards cupboards
• Fit the two brackets (A) on the
cooker hood (see picture).
• Mark out the exact location to drill in
the sides of the cupboards.
• Mount the cooker hood with four
screws (B), washers (C) and the nuts
(D).
Mounting of cooker hood on wall Mounting of cooker hood on wall
Mounting of cooker hood on wall Mounting of cooker hood on wall Mounting of cooker hood on wall
• Mark out where the 4 holes shall be
drilled on the wall. Drill in the
markings with an Ø8 mm drill and fit
rawl plugs into the holes. Use the
template printed on the packaging.
• Fix the screws (A) (see picture).
Leave about 5 mm distance between
the screws and the wall.
• Hook the cooker hood on the screws
(A).
• Remove the grease filter and mount
the screws (B) in the two lower
holes. Remove the grease filter by
pulling it backwards (against the
wall) and then downwards.
• Tighten the screws (A).
• Mount the grease filter.
Mounting the cold air valve Mounting the cold air valve
Mounting the cold air valve Mounting the cold air valve Mounting the cold air valve
Not applicable for recirculation. The
cold air valve consists of a damper seat
with two valves, which shall be fitted
into the hood outlet (see picture).
If there is no other form of ventilation to
expel air from the kitchen than the
hood, the outer end of the valves
should be clipped off and removed.
Insert a pen or something similar
between the valves. These should
open up easily now.
electrolux electrolux installation electrolux
electrolux electrolux
19 19 19
19 19
GB