Connecting The Mediamaster To The Tv; Connecting A Tv And Vcr With Scart Connectors - Nokia MEDIAMASTER 9760 C Owner's Manual

Connecting the Mediamaster to the TV

As most local cable network are distributing TV programmes from
both digital and analogue sources, the signal from the wall net-
work socket will be of the two different kinds:
a Digital signal information to be handled by the Mediamaster.
These signals are sent to the TV through the SCART leads.
b Analogue signals which bypass the Mediamaster through RF
leads.
Due to that you must connect the Mediamaster and the VCR
to the TV as discribed below.
• Connect the SCART lead between the main SCART socket on
the TV and the TV SCART socket on the Mediamaster.
• Connect an RF lead between the TV/VCR output on the Media-
master and the TV aerial input on your TV.
• Connect an RF lead between the TV AERIAL input socket on
the Mediamaster and the network socket.

Connecting a TV and VCR with SCART connectors

Refer to your VCR's manual for full instructions.
• Connect a SCART lead between the main SCART socket on
the TV and the TV SCART socket on the Mediamaster.
• Connect a SCART lead between the VCR
and the AUX SCART socket on the
Mediamaster.
• Connect an RF lead from the TV/VCR output on
the Mediamaster to the TV aerial input on the VCR.
• Connect an RF lead from the RF output on the
VCR to the TV AERIAL input socket on the TV.
• Connect an RF lead between the TV AERIAL input socket
on the Mediamaster and the network socket.
If your TV has a SCART socket, but your VCR does not
• Follow the connections from above, but without the Media-
master/VCR SCART lead.
Your VCR then will have to be tuned to your
Mediamaster as described on page 12.
Network
socket
RF
SCART
Network
socket
RF
VCR
RF
SCART
Mediamaster
SCART
Network
socket
RF
VCR
Mediamaster
SCART
GB 9