Preparing The Remote Control; Connecting The Mediamaster - Nokia MEDIAMASTER 9760 C Owner's Manual

INSTALLATION OF THE MEDIAMASTER
The box for your Mediamaster should contain the
following items:
• the Mediamaster
• a remote control with 2 AAA batteries
• a SCART lead (fully featured 1,0 metre)
• an Owner's Manual
• a Software License agreement
About the SCART sockets
• The rear panel of the Mediamaster is equipped with 2 SCART
sockets (see diagram). When you connect other products
to any of these sockets, always use fully featured SCART
leads (as supplied). There are "less well specified" SCART
leads on the market and picture quality could be reduced if you
use them.

Preparing the Remote Control

• Remove the cover on the battery compartment at the bottom
of the remote control.
• Insert the 2 AAA (1,5 V) batteries, as shown in the diagram,
taking care to observe the + and - markings indicated inside.
• Replace the cover.

Connecting the Mediamaster

There are many different types of TV/VCR and other equipment
that you can connect to the Mediamaster.
In this manual you will see some of the most common ways to
connect your equipment.
If you use RF leads you will have to tune your TV and VCR to the
Mediamaster output channel (see page 12).
GB 8
SCART lead Remote control
Owner's manual License
agrement
SCART socket