AOpen CRW2440 User Manual page 14

Hardware Installation
1. Remove the housing or casing of your computer. Be careful of any sharp edges,
which might be hidden inside your computer.
2. If there is not any other CD-ROM drive installed in your system. We recommend
installing the CD-R/RW in the Secondary IDE port. It is unnecessary to adjust any
other jumpers on the CD-R/RW. Proceed to step 4 for further installation.
3. If a CD-ROM drive is already installed in your system.
We recommend that you install the CD-ROM on the Secondary IDE
channel as the master device (MA), and the CD-R/RW on the Secondary
IDE channel as the slave device (SL). Please follow the steps below to
fulfill this arrangement.
Ÿ
First make sure that your Secondary IDE cable has two ports available for two
Ÿ
IDE devices. If not, ask your main board vendor or purchase one from computer
hardware stores.
Ÿ
If the CD-ROM drive was installed in the Primary IDE channel, disconnect it
from the Primary IDE cable.
Ÿ
Adjust the Device Configuration Jumper of the CD-ROM drive to "Master" (MA)
position.
Ÿ
Adjust the Device Configuration Jumper of the CD- R/RW to "Slave" (SL)
position.
-- E-10 --